Thingiverse
Caliburn Brass Breech Parts
by Remzak
41
Downloads
31
Likes
0
Makes
The two parts required to create a brass breech for your Caliburn. Both have a TIGHT fit on 9/16" brass, the goal is to completely immobilize the brass, so sanding will be necessary.
Use the two holes on the ram not used for the priming parts to insert a pin through your breech, preventing vacuum loading.
I'm working on a tutorial now, but the intent is for one piece of 9/16" brass to be attached to the ram and surround the darts, acting as the sliding breech, while the muzzle holds the 9/
Use the two holes on the ram not used for the priming parts to insert a pin through your breech, preventing vacuum loading.
I'm working on a tutorial now, but the intent is for one piece of 9/16" brass to be attached to the ram and surround the darts, acting as the sliding breech, while the muzzle holds the 9/
Sign in to leave a comment
Sign in