Prusa Spool holder Table stand

This is a squashed Bug to use your one-piece Prusa spool holder as a Table Spool holder.
I had a dual spool holder with my Mk3 so I could justify making this over seperate spool holders.
My settings with PLA:
Layer 0.2 mm
60% infill cubic
Support on
-needed around 180 gramm of PLA with these settings.

Edit:
My spool holder had a 30mm wide clip on area. Printed versions from Prusa have a 35mm wide area. I enlarged my model a little to make them work as well. Clip on area on the model