Thingiverse
Toyota C-HR phone holder
by namadori
15
Downloads
9
Likes
1
Makes
Cell phone holder for Toyota C-HR.
The bracket is printed in two sections, to fit in the Ender 3 bed (23x23 cm).
The left bracket is modeled to be printed upside down. The holder is a bit too high, use a negative offset (-1mm should be enough) when placing on print bed to make sure the full bracket length is touching the surface.
To avoid scratches I lined the interior of the bracket with velvet self-adhesive paper (like [this one](https://www.amazon.com/Adhesive-Velvet-Contact-Jewelry-
The bracket is printed in two sections, to fit in the Ender 3 bed (23x23 cm).
The left bracket is modeled to be printed upside down. The holder is a bit too high, use a negative offset (-1mm should be enough) when placing on print bed to make sure the full bracket length is touching the surface.
To avoid scratches I lined the interior of the bracket with velvet self-adhesive paper (like [this one](https://www.amazon.com/Adhesive-Velvet-Contact-Jewelry-
Sign in to leave a comment
Sign in