Thingiverse
Ender 3 Direct Drive Mount Hero Me Edition
by paul2k1uk
61
Downloads
42
Likes
0
Makes
This is my remix for Hero Me fan duct setup.
To be tested
Testing completed and is working great. You will need to extend E Wiring slightly to allow movement over X direction
With this mod iv now got retraction down to 2mm and poss less
There is a slight tilt to the mount and im going to look to improve this soon
Should print ok at 0.2 layer with 2 walls min. with high infill. confirmed fitment with low infill if needed.
Advised PETG or ABS material for print
Pictures to come
To be tested
Testing completed and is working great. You will need to extend E Wiring slightly to allow movement over X direction
With this mod iv now got retraction down to 2mm and poss less
There is a slight tilt to the mount and im going to look to improve this soon
Should print ok at 0.2 layer with 2 walls min. with high infill. confirmed fitment with low infill if needed.
Advised PETG or ABS material for print
Pictures to come
Sign in to leave a comment
Sign in