Creative Webcam VF0350 16mm tube/rod mount

I had a old VF0350 webcam and an Raspberry PI, so I designed a mount for a 16mm tube/rod.

Instructions:
* Print the parts with 100% infill. (Print the part for the webcam standing up, using brim, no supports)
* Remove the two Philips head screws from the webcam and then pop out the exiting holder.
* insert the new holder into the webcam and use a M3 screw in the base of the holder that inserts into the webcam. it simply adds compression and may not be needed. make sure it is short eno