Thingiverse
Railcore II Spool Holder
by justingray
8
Downloads
3
Likes
0
Makes
This spool holder is a remix of a remix of a remix :)
Its for the Railcore II printer. It requires a short length of M6x100 threaded rod and 4 M6x100 nuts.
Use two nuts to secure the rod into the spool arm (alternatively you can thread in a set-screw if you wish). Two more nuts are used on the two end-caps. You need two end caps so that you can tighten them into each other and lock on and don't spin off.
The picture I took of the final end-caps shows them as solid. The solid design w
Its for the Railcore II printer. It requires a short length of M6x100 threaded rod and 4 M6x100 nuts.
Use two nuts to secure the rod into the spool arm (alternatively you can thread in a set-screw if you wish). Two more nuts are used on the two end-caps. You need two end caps so that you can tighten them into each other and lock on and don't spin off.
The picture I took of the final end-caps shows them as solid. The solid design w
Sign in to leave a comment
Sign in