Thingiverse
InMoov Square-Potholder for HV2060MG (Shoulder)
by Wunschpunsch
8
Downloads
2
Likes
0
Makes
Custom potholder for the InMoov shoulder.
IMPORTANT:
The angle I used for this part works for my InMoov but MIGHT NOT work for yours due to manufacturing differences. Be careful testing it, you might set your servo to an angle of 20° first and lower it step by step to make sure it fits.
The potentiometer of the HV2060MG rotates slightly more than 180° so I tested out different angles and ended up with a 13° offset (setting the hole for the potentiometer perpendicular to the whole mount won
IMPORTANT:
The angle I used for this part works for my InMoov but MIGHT NOT work for yours due to manufacturing differences. Be careful testing it, you might set your servo to an angle of 20° first and lower it step by step to make sure it fits.
The potentiometer of the HV2060MG rotates slightly more than 180° so I tested out different angles and ended up with a 13° offset (setting the hole for the potentiometer perpendicular to the whole mount won
Sign in to leave a comment
Sign in