3030 Extrusion Spool Holder

Spool Holder for 3030 Extrusions
====================

Here is the one and only versatile Holder for your Filament-Spools.
Just hang it into your 3030 Extrusion and off you go!

The slot-clearance needs to be at least **8 mm**.

Best use the shown orientation to print.
Use a little bit of *Support* at the hanger part of the piece. Check picture.

In the attachments you will find an .stl and an .3mf - both are the same version of the Part.


### Measurements of the Spool:
Width (ma