Thingiverse
Case / Enclosure for NodeMCU (v2 Amica) DHT and Relay
by evil_drummer
22
Downloads
8
Likes
0
Makes
I needed a enclosure for my temperature based fan control of my 3D Printer Housing.
Measurements are:
70mm x 63mm x 31mm
The NodeMCU fits quite well and all other Pins are still available. Maybe i add a second top piece where you can tighten the connectors of the relay and a second hole for the AM2301 where you can place the pins outside so the Sensor will layout flat on the top. And a base with mounting points but with this weight any good double sided tape will do its job :)
Yo
Measurements are:
70mm x 63mm x 31mm
The NodeMCU fits quite well and all other Pins are still available. Maybe i add a second top piece where you can tighten the connectors of the relay and a second hole for the AM2301 where you can place the pins outside so the Sensor will layout flat on the top. And a base with mounting points but with this weight any good double sided tape will do its job :)
Yo
Sign in to leave a comment
Sign in