Thingiverse
Xiaomi mijia scooter M365 rear light
by Bur_lion
83
Downloads
86
Likes
1
Makes
My rear light broke... So i designed my own...
Im use black and clear PLA for printing... But im think its better if it printing black and clear red PETG.
You need small pice of circuit board (5x10mm). 2 SMD leds and some wires...
1. Tinker and solder the wire and LEDs.
2. Print the parts. For the top it is better to use a circular filling.
3. Insert 2 self tapping nuts into the bottom. Use M3 nuts.
4. Pull the wire through the center hole and fix the board with a drop of super glue.
5. I
Im use black and clear PLA for printing... But im think its better if it printing black and clear red PETG.
You need small pice of circuit board (5x10mm). 2 SMD leds and some wires...
1. Tinker and solder the wire and LEDs.
2. Print the parts. For the top it is better to use a circular filling.
3. Insert 2 self tapping nuts into the bottom. Use M3 nuts.
4. Pull the wire through the center hole and fix the board with a drop of super glue.
5. I
Sign in to leave a comment
Sign in