Anet A8 Creality Hotend Mount

I found the Creality hotend design to be easier to maintain and work with over the E3D setup everyone was using on the A8

This plate will allow you to mount a Ender-3 style hotend to your Anet A8 with a few supporting mods to your bowden conversion.

You will need to add a 12 volt to 24 volt step up to get 24 volts to this style hot end. I also run mine through a mosfet.

I used the Hero v2s fan setup made by kelokera. https://www.thingiverse.com/thing:3020267

Also be sure to retune y