Thingiverse
Mini Sanding Drum
by reavercon
36
Downloads
30
Likes
0
Makes
A small DC powered drum sander.
Uses 1 3/16" x 9" | 30 x 229mm sand paper.
I use Norton 93x 229mm sandpaper and just cut it to 30mm.
The two small DC motors are 16.5k RPM with little torque to prevent overheating PLA prints. Be sure to dab water on the drum to keep the parts cool. Not to much or you will be taking a shower.
I used 8 AA batteries to compensate for the low torque of the small DC motors I used.
The sandpaper is held in with a small plastic wedge (Not Included) o
Uses 1 3/16" x 9" | 30 x 229mm sand paper.
I use Norton 93x 229mm sandpaper and just cut it to 30mm.
The two small DC motors are 16.5k RPM with little torque to prevent overheating PLA prints. Be sure to dab water on the drum to keep the parts cool. Not to much or you will be taking a shower.
I used 8 AA batteries to compensate for the low torque of the small DC motors I used.
The sandpaper is held in with a small plastic wedge (Not Included) o
Sign in to leave a comment
Sign in