Thingiverse
Spool holder 20x40/CR-10s + filament sensor/guide
by redarflap
13
Downloads
8
Likes
0
Makes
This is a spool holder designed for the Creality CR-10s.
The base parts fit the 20x40 profile of the CR-10s. It is a very tight fit on the CR-10s and was not tested on other 20x40 rails.
The runout sensor holder was designed for the newer smaller type of filament sensor for the CR-10s.
!!!!! For the sensor to fit, all the unneccessary plastic has to be cut away, so it has a nice flat bottom side.
The sensor is mounted using the same holes as the 3 screws for the lid, but from the bo
The base parts fit the 20x40 profile of the CR-10s. It is a very tight fit on the CR-10s and was not tested on other 20x40 rails.
The runout sensor holder was designed for the newer smaller type of filament sensor for the CR-10s.
!!!!! For the sensor to fit, all the unneccessary plastic has to be cut away, so it has a nice flat bottom side.
The sensor is mounted using the same holes as the 3 screws for the lid, but from the bo
Sign in to leave a comment
Sign in