Thingiverse
garden stake 35mm mount
by vk5zbr
8
Downloads
3
Likes
0
Makes
Garden stake mount for pole. for 35x35mm stake.
It is a nice tight clip on action, some holes is you want to stop is sliding down or pulling off.
I use to it hold my daughter wind mill that had a pole diameter of 18mm.
Was printed in black ABS to survive the sun. paint it if you want the UV to not effect the ABS. being black it should last a while.
slicer, shell 3mm to give flex with out cracking when flexing over the wooden stake.
hot end 245C, build surface 90deg in a enclosu
It is a nice tight clip on action, some holes is you want to stop is sliding down or pulling off.
I use to it hold my daughter wind mill that had a pole diameter of 18mm.
Was printed in black ABS to survive the sun. paint it if you want the UV to not effect the ABS. being black it should last a while.
slicer, shell 3mm to give flex with out cracking when flexing over the wooden stake.
hot end 245C, build surface 90deg in a enclosu
Sign in to leave a comment
Sign in