Thingiverse
Shower Thermostat Hansgrohe button
by jsyrovat
9
Downloads
2
Likes
0
Makes
Very precise design of a Shower Thermostat Hansgrohe button, which often fails after some years of use. This printed button allows it to be replaced, without the need of replacing the whole installation.
Just print it as it is, ABS is strongly recommended due to wet environment, where it will be used. Rip of the built in support and click it into the device (note of the correct side, there is a small pin with corresponding opening in printed part from bottom).
Just print it as it is, ABS is strongly recommended due to wet environment, where it will be used. Rip of the built in support and click it into the device (note of the correct side, there is a small pin with corresponding opening in printed part from bottom).
Sign in to leave a comment
Sign in