Thingiverse
Flood Light Tower 00 OO HO
by bluetobits
181
Downloads
92
Likes
0
Makes
Flood light tower
The files contain an assembled truss gantry. which may print for you. The parts list contain the truss gantry disassembled. Use CA to glue the parts together. the floods can be positioned at any angle then glued. Glue in the LEDs
It's fiddly to wire. It took me 90 minutes to make 2.
towertruss.stl is the internal z section truss to replace one I damaged.
Electrics
1. 3 x 3528 LEDs to be wired in series with a 150 ohm resistor for 12V operation. I used very thin enamell
The files contain an assembled truss gantry. which may print for you. The parts list contain the truss gantry disassembled. Use CA to glue the parts together. the floods can be positioned at any angle then glued. Glue in the LEDs
It's fiddly to wire. It took me 90 minutes to make 2.
towertruss.stl is the internal z section truss to replace one I damaged.
Electrics
1. 3 x 3528 LEDs to be wired in series with a 150 ohm resistor for 12V operation. I used very thin enamell
Sign in to leave a comment
Sign in