Hypercube evolution bed leveling knob (HEVO)

I have found in the past that large leveling knobs are far better than small ones, so I created one that works for the HEVO. The nut is a VERY tight fit in the knob. This is by design. You can either pull out into place by screwing it from the top (before you put it in the printer and use a washer), or I used a longer m3 screw, put the nut part way on the screw, then hammered out in. The screw acts as a guide and keeps the nut level. Look at the pics for what I did.

I did my best to minimize