Thingiverse
Machinder - Mazinger Z Jet Scrander
by bourno16
41
Downloads
57
Likes
0
Makes
This is a model of the Scrander for the 24" jumbo machinder figure called Mazinger Z.
Where you see small holes, these are locations to use 1/4" neodymium magnets. You could glue the pieces into place instead. You may need to cut the fin on your own, if too large for your print bed.
The belt is close to the Mazinger Z waist, but isn't a perfect matched fit. I loaded 2 different jet nozzles, one with grooves added, and another without.
Not included:
I used 3/4" wood dowel if you prin
Where you see small holes, these are locations to use 1/4" neodymium magnets. You could glue the pieces into place instead. You may need to cut the fin on your own, if too large for your print bed.
The belt is close to the Mazinger Z waist, but isn't a perfect matched fit. I loaded 2 different jet nozzles, one with grooves added, and another without.
Not included:
I used 3/4" wood dowel if you prin
Sign in to leave a comment
Sign in