Upgrading the Anet3D V1.5 board to a MKS Gen 1.4 board

I am posting this because I couldn't find any instructions to migrate between these two boards.

Please see this website for all of the details. Upgrading from ANET3D V1.5 to MKS Gen 1.4

On the end stop connectors; PLEASE make sure you move the right pin, or you could end up shorting out (KILLING) your new MKS board when the end stop switch is activated.

Note: this is for migrating from the Anet to the MKS board.

You will need an MKS Gen 1.4 and stepper drivers.

If you are going t