Thingiverse

CR-10S Pro Feed Funnel

by mack648

19 Downloads

9 Likes

0 Makes

Download Model

3D Printer Accessory 3d printer acessory 3D Printer Parts CR-10 CR-10S PRO CR10 Creality Creality CR-10s feeder feed funnel filament filament feed Filament Feeder filament guide Funnel funnels guide Printer Accesory Printer Accessories printer parts

The only complaint I had with the CR-10S Pro is the feed angle of the filament into the sensor block was so high that it would shave the filament going in and make a mess. This funnel solves that issue. Now there's no complaints! (well, PLA on PLA squeaks a little depending on the brand, but I just leave the room.)

If this piece helps you, tips are welcome and always appreciated! (But not necessary)

**Update** I noticed it wiggles a little, so I've changes the status to WIP. I'll play with

Source

Thingiverse

Comments