Thingiverse
Filament Cutter (3mm)
by JimmerJammer
5
Downloads
2
Likes
0
Makes
Redesigned for for 3mm filament and a 9mm blade end - as the original's 10mm doesn't seem common in the US. (10mm does not refer to the length of cutting edge, it refers to the perpendicular measure to the blade edge.)
Honestly, it's tough to love. This technique probably works MUCH better for 1.75mm filament, due to the thinner diameter. It takes a bit of finger strength to pop through 3mm filament, but if people want this, they can take advantage of my foray. Maybe PLA is easier than PETG,
Honestly, it's tough to love. This technique probably works MUCH better for 1.75mm filament, due to the thinner diameter. It takes a bit of finger strength to pop through 3mm filament, but if people want this, they can take advantage of my foray. Maybe PLA is easier than PETG,
Sign in to leave a comment
Sign in