Thingiverse
Vive Tracker to 1" pole adaptor
by IonEwe
8
Downloads
5
Likes
0
Makes
Darth Maul 1" Pole Adaptor for beat saber.
This will be updated for (R3) better printing, (R3) connector optimization and 1/4-20 refinement.
R3 prints in 2 parts. Print the adaptor with the wide part down. Supports are built into the model for the holes.
heat form or tap thread the shaft mounting set screws.
The PCB version of the insert has a 0.062" inset to cut a pcb and solder to. The PCB design will be added later.
The Plain insert can use 14 AWG solid wire as the contacts.
i
This will be updated for (R3) better printing, (R3) connector optimization and 1/4-20 refinement.
R3 prints in 2 parts. Print the adaptor with the wide part down. Supports are built into the model for the holes.
heat form or tap thread the shaft mounting set screws.
The PCB version of the insert has a 0.062" inset to cut a pcb and solder to. The PCB design will be added later.
The Plain insert can use 14 AWG solid wire as the contacts.
i
Sign in to leave a comment
Sign in