Thingiverse
candy butter
by losem
2
Downloads
2
Likes
2
Makes
this is a tool to safety open up the top of a soda can
**UPDATE**
after the first print was a total structural failure. I didn't do enought infill (crank it). The handle just snapped off with the top. I think I'd up scale it a bit more too. I'm going to change the bottom so you won't need support
**Update**
This is copy and paste so far as I can tell. I made one with 40% infill and 2mm wall and its a tank. You could kill with this thing. So a 30% should be just fine but 20 i
**UPDATE**
after the first print was a total structural failure. I didn't do enought infill (crank it). The handle just snapped off with the top. I think I'd up scale it a bit more too. I'm going to change the bottom so you won't need support
**Update**
This is copy and paste so far as I can tell. I made one with 40% infill and 2mm wall and its a tank. You could kill with this thing. So a 30% should be just fine but 20 i
Sign in to leave a comment
Sign in