Thingiverse
MPCNC Redux Foot and Corner for Hexagon Machinescrew
by eglische
5
Downloads
2
Likes
0
Makes
Well i ran into the Problem that i can't fasten the Nut and the Screw/Fastener on my MPCNC foot.
I could also not get to it with pliers. I use nylon secured nuts, because i am a bit paranoid... so holding the nuts is pretty much necessary to fasten it together.
So what i did is recreate the part with flush surfaces on either side, so now you can easily bolt it together.
Print settings I used are:
35% Fill, 0.2mm Layers and I like gyroid. Comes out at around 16ish hours to print for the
I could also not get to it with pliers. I use nylon secured nuts, because i am a bit paranoid... so holding the nuts is pretty much necessary to fasten it together.
So what i did is recreate the part with flush surfaces on either side, so now you can easily bolt it together.
Print settings I used are:
35% Fill, 0.2mm Layers and I like gyroid. Comes out at around 16ish hours to print for the
Sign in to leave a comment
Sign in