Thingiverse
2020 Rubber Foot
by BuilderJoe
6
Downloads
4
Likes
0
Makes
The original feet were to high for my needings. So I tried to lower them and instead of mounting a rubber part at the bottom I design a ball at the bottom.
The whole thing was printed with an elastic material.
The third hole in the middle of the higher foot will not be need, cause at that position the 2020 have the edge connector.
The whole thing was printed with an elastic material.
The third hole in the middle of the higher foot will not be need, cause at that position the 2020 have the edge connector.
Sign in to leave a comment
Sign in