Thingiverse
HobbyKing Desert Fox Rear Suspension Arm
by Thirtybird
23
Downloads
13
Likes
0
Makes
Rear Suspension Arm for the HobbyKing Desert Fox
Modeled as close to the original as possible, which makes for an ugly print with supports. It's "good enough", the length and width and holes are all in the right spot, the structure is just offset a little bit.
I've printed in PETG with 100% infill and after more durability testing, will see where it breaks, and reinforce from there.
2019-Mar-25: The PETG arm at 100% infill snapped at the outer end - not along layer lines either. It al
Modeled as close to the original as possible, which makes for an ugly print with supports. It's "good enough", the length and width and holes are all in the right spot, the structure is just offset a little bit.
I've printed in PETG with 100% infill and after more durability testing, will see where it breaks, and reinforce from there.
2019-Mar-25: The PETG arm at 100% infill snapped at the outer end - not along layer lines either. It al
Sign in to leave a comment
Sign in