Thingiverse
Minimalist "2018" Transistor Tester Stand
5
Downloads
4
Likes
0
Makes
A minimalist stand for holding this model of transistor tester at a comfortable use/viewing angle. Also, a little lever extender add-on.
Hardware:
* Glue (I used JB Weld, superglue and the like should also work fine)
* 2-4 16mm M3 screws
* Potentially 2-4 M3 nuts
Print the face and base out, flat sides down. Glue them together and screw the tester on. The holes were just tight enough for an interference fit on mine, but you may need the nuts to secure it.
The face plate has a flat
Hardware:
* Glue (I used JB Weld, superglue and the like should also work fine)
* 2-4 16mm M3 screws
* Potentially 2-4 M3 nuts
Print the face and base out, flat sides down. Glue them together and screw the tester on. The holes were just tight enough for an interference fit on mine, but you may need the nuts to secure it.
The face plate has a flat
Sign in to leave a comment
Sign in