Thingiverse
Ender-3 Pro, Y-axis damper mount remix
by ALZHEM
126
Downloads
65
Likes
2
Makes
CDeviant designed the only piece that, for me, fits the Ender-3 Pro well. It is SUPER sturdy and it just work.
When I installed CDeviant's I run into a few of problems:
- The stepper motor was a bit too close to the piece wall on which it was mounted, so the pulley was relatively close to that wall too. This resulted in noise produces by the belt touching the side of the pulley. This noise can result in wear over the time.
- Putting the belt over the pulley was a bit challenging due to the
When I installed CDeviant's I run into a few of problems:
- The stepper motor was a bit too close to the piece wall on which it was mounted, so the pulley was relatively close to that wall too. This resulted in noise produces by the belt touching the side of the pulley. This noise can result in wear over the time.
- Putting the belt over the pulley was a bit challenging due to the
Sign in to leave a comment
Sign in