Remix of Ender 3 Octoprint Set Up with Power and Light Remote Control

Remix of https://www.thingiverse.com/thing:3063845

I changed the base to use 2 of the higher voltage relays recommended in original:
https://www.aliexpress.com/item/30A-5V-1-Channel-Relay-Module-Board-With-Optocoupler-H-L-Level-Triger/32814917488.html?

You only need two, one for power and one for 24V LED Lights. The original design had a relay for both power and ground. I just covered the 5 volt pin on the USB cable from RPI to board so it doesn't draw power from the PI.

See the origi