MyDD - Bondtech BMG Direct Drive Extruder for CR-10 (BLTouch, EZABL, E3D V6, Volcano, ...)

I merged several parts together to create a lighter extruder than the remix source.

Instead of screwing directly into the plastic, I added brass inserts for M3 screws.
The fan shroud is used from the Prusa MK3 R3.
The fan for the cold end is a 40x40x20 Noctua fan
The part cooler fan is a Sunon 5015.

Just a small comparison on the weight just for the printed parts:

Petsfang Bondtech Extruder: 125g
Source of this remix: 82g
My design: 66g


I used the following fan shroud:
"Fan_