Anycubic Kossel Linear Plus Magnetic Arms Alignment jig

This is a helping tool for /thing:2859992
As the carbon rods are very difficult to saw to the EXACT same length, this jig helps you to align each pair of carbon rods to be the same length.

Instructions:
- Screw the 20mm set screws into the steel balls
- Cut the rods to rough length (preferably about 1mm shorter than the suggested 257mm)
- Put 2K epoxy in each end of the carbon tubes
- Stick 4 of the set screws with the steel balls into the rods ends
- Insert 2 rods into this jig
- Let