Thingiverse
Mini Talon R9 antenna support
by FreeFlight
19
Downloads
21
Likes
0
Makes
Here is my small support for Frsky R9 antenna (new ones).
Has been designed in order to install in the rear part of my mini Talon where there is the square pocket in the foam.
It's made of two parts, one is the fixture and the other is the upport itself.
Total weight it's less than 7 grams.
Two parts are required in order to print without supports. If you print with ABS you can glue the parts with acetone slurry otherwise use epoxy.
This is version 3 that consider the lenght of the an
Has been designed in order to install in the rear part of my mini Talon where there is the square pocket in the foam.
It's made of two parts, one is the fixture and the other is the upport itself.
Total weight it's less than 7 grams.
Two parts are required in order to print without supports. If you print with ABS you can glue the parts with acetone slurry otherwise use epoxy.
This is version 3 that consider the lenght of the an
Sign in to leave a comment
Sign in