Thingiverse
UFO Canopy
by mothy
7
Downloads
7
Likes
0
Makes
A simple canopy that prints without supports.
This fits cameras that are "mullet" modded or have a seperate vtx. Print in TPU with .6mm wall thickness with 2 shells, no support material needed. When its done just push your camera lens through the opening and it should be a snug fit, there is a tiny rim that should keep it flush, I use a tiny dab of bondic once I've twisted the camera to the correct angle/orientation. You should get a 10 degree angle with this canopy. If you print this in PLA y
This fits cameras that are "mullet" modded or have a seperate vtx. Print in TPU with .6mm wall thickness with 2 shells, no support material needed. When its done just push your camera lens through the opening and it should be a snug fit, there is a tiny rim that should keep it flush, I use a tiny dab of bondic once I've twisted the camera to the correct angle/orientation. You should get a 10 degree angle with this canopy. If you print this in PLA y
Sign in to leave a comment
Sign in