Thingiverse
Small Limit Switch Mount
17
Downloads
11
Likes
0
Makes
This will mount a small microswitch to the side of any standard 2020 extrusion / Openbuilds / MakerSlide. The microswitch is recessed into the extrusion's slot, giving it a very low profile.
It includes a small wiring duct, to pass wires from the side of the mount, down underneath where they can reach the switch terminals. There's enough space for 2 wires, roughly 1mm diameter each.
It is intended to be used as a Limit Switch / Endstop / Homing Switch. Im currently using them on an X-Carv
It includes a small wiring duct, to pass wires from the side of the mount, down underneath where they can reach the switch terminals. There's enough space for 2 wires, roughly 1mm diameter each.
It is intended to be used as a Limit Switch / Endstop / Homing Switch. Im currently using them on an X-Carv
Sign in to leave a comment
Sign in