Thingiverse
Prusa i3 Mk3/Mk3S/Mk3S+ reinforced PSU replacement brace
by cordilon
81
Downloads
58
Likes
2
Makes
A brace to reinforce your Mk3's frame in case you want to move the PSU elsewhere (e.g. outside enclosure).
Other designs seemed not sturdy enough for my taste, so I designed this one with stability in all directions in mind, while saving a good amount of filament and giving it a nice industrial look. It fit perfectly on my frame and doesn't bulge a single bit!
What you will need to install it:
- 2 x M3x10mm hex screw for the horizontal holes (just take the old screws)
- 2 x M4x16mm screw f
Other designs seemed not sturdy enough for my taste, so I designed this one with stability in all directions in mind, while saving a good amount of filament and giving it a nice industrial look. It fit perfectly on my frame and doesn't bulge a single bit!
What you will need to install it:
- 2 x M3x10mm hex screw for the horizontal holes (just take the old screws)
- 2 x M4x16mm screw f
Sign in to leave a comment
Sign in