Thingiverse
Small Filament Guide for bowden extruder
by C47_3D
32
Downloads
22
Likes
1
Makes
Small filament guide for bowden extruder with screw thread.
It can help with installing 'normal' filaments too. Sometimes I had some problems with this because of inside screw thread.
Tested in JG Aurora A1 (I printed my Piggy with TPU), before that elastic filament was going out of the tube from time to time.
INSTALLATION
You need to unscrew the black metal plate (on photo: 1,2,3) and take it off.
Drive in the guide up to some resistant (don't use too much force).
Then, if the guide i
It can help with installing 'normal' filaments too. Sometimes I had some problems with this because of inside screw thread.
Tested in JG Aurora A1 (I printed my Piggy with TPU), before that elastic filament was going out of the tube from time to time.
INSTALLATION
You need to unscrew the black metal plate (on photo: 1,2,3) and take it off.
Drive in the guide up to some resistant (don't use too much force).
Then, if the guide i
Sign in to leave a comment
Sign in