Garmin Striker 7SV / 7CV Plus Visor

Here is another visor. This time for the Garmin Striker Plus 7SV and 7CV Sounder/Fish Finders

Its a very simple print with no supports at all needed. Its a fairly long print though, at over 20 hours. (0.2mm @ 50mm/s)

Print with at least 4 perimeters. There is very little infill, but use at least 50% for some extra rigidity.

4x M4 x 6mm Stainless Steel screws are recommended. (5mm would be ok) (The mounting backing is 2.5mm thick and the Striker Plus holes are 4.8mm deep)

If you downl