Thingiverse
Fritz Fon C5 Belt Clip Two Parts
by JulesLobo
7
Downloads
3
Likes
0
Makes
Hej fellow Makers!
All existing belt clips for the Fritz Fon C5 on Thingiverse are one-piece and therefore only partially suitable for FDM printers. If you print along the clip, it's stable, but not the cover and vice versa. The clip of these models likes to break along the layer line, so I designed a two-piece clip. Depending on how accurate your printer is, you still have to sand a bit with fine sandpaper until it fits and to smooth out the possibly sharp edges. One drop of superglue and it
All existing belt clips for the Fritz Fon C5 on Thingiverse are one-piece and therefore only partially suitable for FDM printers. If you print along the clip, it's stable, but not the cover and vice versa. The clip of these models likes to break along the layer line, so I designed a two-piece clip. Depending on how accurate your printer is, you still have to sand a bit with fine sandpaper until it fits and to smooth out the possibly sharp edges. One drop of superglue and it
Sign in to leave a comment
Sign in