Thingiverse
FridayFPV SlateRS Arm Guard V1
4
Downloads
3
Likes
0
Makes
Protects the end of your FridayFPV SlateRS arm from delamination in a hard crash.
These will fit either the 5 or 6" arm, front and rear. The print slides over the end of the arm and the motor is bolted down on top of the print. This arm guard also clips in underneath the edges of the arm to give some extra protection.
These will fit either the 5 or 6" arm, front and rear. The print slides over the end of the arm and the motor is bolted down on top of the print. This arm guard also clips in underneath the edges of the arm to give some extra protection.
Sign in to leave a comment
Sign in