Hornady Shell Plate Spanner

I've created a shell plate wrench / spanner for use with the Lock and Load AP Press. The spanner has been tested in shell plates for #8 (9mm), #45 (45APC), #37 (5.7x28), and #16 (223).

I would recommend printing the one without the offset first. A 1mm offset was added in case your printer is printing too large because for 9mm (and 45) this spanner is very snug off of my Ender 5 with Normal 0.15 layers 80% infill (w/ hex triangles) in PLA...

Other designs on here did not fit my #8 or #45