Thingiverse
DIN Rail Mount for CNC Parallelport Breakout Board
by wiredog
8
Downloads
2
Likes
1
Makes
This is 35mm DIN-Rail mount (aka 35mm Hutschiene) for a CNC Parallelport breakout board used to connect stepper motor drivers to the parallel port of a computer.
The mounting holes on top have a diameter of 2.3mm to allow to be drilled and thread-cut for M3 screws. The holes are 55mm apart.
The mount can be attached and deattached by using a flat screwdriver. Two of them are needed to fix the breakout board to the DIN rail.
Printed using 100% infill
The mounting holes on top have a diameter of 2.3mm to allow to be drilled and thread-cut for M3 screws. The holes are 55mm apart.
The mount can be attached and deattached by using a flat screwdriver. Two of them are needed to fix the breakout board to the DIN rail.
Printed using 100% infill
Sign in to leave a comment
Sign in