35mm Handlebar torch mount.

These mounts are for use on 35mm handlebars and a seat tube of 31.5mm. They allow you to fit a torch to the bars, anything around a 28.5mm torch/flashlight is held in nice and tight. You could mount smaller by using some form of padding to bulk out the hole.The rear is designed with an O-Light Clip Pro in mind. To get this to fit snugly, i had to remove the rear clip and spring (easily done using a T5 Torx bit). Maximum seat tube size is 31.5, please remember if you use a dropper, to ensure the lower part is no bigger than this.I have put up the STL files to allow you to adjust them as needed. The file is in PLA, but i'm hoping to make the rear mount a mix of PLA for the clamping part, and TPU for the pocket area.To affix the mounts to the bike, i simply used M3 Cap Head hardware.DO NOT overtighten the hardware, it may just pull straight through. The OEX flashlight I use comes with a knurled grip, but i have tried smooth parts and the clamping force is way more than would be needed