Thingiverse
36 quail egg holder
by billywhizzy
89
Downloads
77
Likes
0
Makes
I have made these 36 quail egg holders for button and coturnix jumbo quail. The stl is the smaller egg size. If required for jumbo eggs, increase size in slicer to 110%.
They are very useful for transportation of eggs or for turning the eggs prior to incubation.
Bottom layers 2
Top layers 3
Infill 15-30%
PLA Bed 60C 210C throughout print to avoid warping
0.2 or 0.3mm resolution
No filament cooling required.
First layer 30mm/sec then 60mm/sec
Depending on your settings my print time ranged from 7hrs 30 mins to 11 hours
The STL file has closed ends of the egg cup. If you would like them open, either stop the printer or else modify the STL by chopping a bit from the top to expose a hole.
They are very useful for transportation of eggs or for turning the eggs prior to incubation.
Bottom layers 2
Top layers 3
Infill 15-30%
PLA Bed 60C 210C throughout print to avoid warping
0.2 or 0.3mm resolution
No filament cooling required.
First layer 30mm/sec then 60mm/sec
Depending on your settings my print time ranged from 7hrs 30 mins to 11 hours
The STL file has closed ends of the egg cup. If you would like them open, either stop the printer or else modify the STL by chopping a bit from the top to expose a hole.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
