360 Degree Platform for Microscope

Inspired by Steve mould's latest video, except the same effect is achieved mechanically rather than with optics. Some 28byj-48 drivers may not fit into the screw holes. If they dont, use super glue to attach.I suggest using an arduino nano without pins and desoldering IN1 to IN4 on the stepper driver. Solder all wires together instead.The arduino nano attaches with glue, along with the thin elecronics cover.When assembling the white screw, drill/ream the hole with 5mm. Hammer in screw with the spacer installed. I used a small amount of CA glue too How to use:1. Record a video of the target doing a 360 degree spin. I suggest leaving a few seconds extra2. In an editing software, rotate the whole video 360 degrees in the opposite direction to cancel the spin.3. Add a circular mask (optional) Hardware:28byj-48 Stepper motor28byj-48 Stepper driverArduino nano10k potentiometer2mm*12mm pin x6m3*6 machine screw x16m3*(12 to 20) machine screw x2m3*4 heatset insert x18 Wiring:Potentiometer w