Thingiverse
Vortex Manipulator
by PiperSA
58
Downloads
47
Likes
0
Makes
I was asked by a friend if I could make a print of a Vortex Manipulator the same as the one Dr Who? and Torchwood have so I found some pitchers and copped them and made this I did about 11 copes improved it with each print
I used PLA and ABS with a 0.25 and a 0.35 Tip with supports the size of it is in the black pitcher as close as I could guess
The 1/4 it is round fins/vent holes is a lot of long holes air will go through they start to print from off the bed it was easier to slice this wa
I used PLA and ABS with a 0.25 and a 0.35 Tip with supports the size of it is in the black pitcher as close as I could guess
The 1/4 it is round fins/vent holes is a lot of long holes air will go through they start to print from off the bed it was easier to slice this wa
Sign in to leave a comment
Sign in