Thingiverse
Ender3 pro - power OFF mounting box
by Angelo_daje
34
Downloads
23
Likes
0
Makes
Re-elaboration of the idea provided by
https://www.thingiverse.com/thing:3333899.
Still uses the high voltage switch so please be careful.
The principle is; when the printer finish its job, it waits for 5 minutes and then move to max z axis. When the Max Z is reached one of the wheel mechanically touch a switch which interrupt the main power.
To make the Printer wait for 5 minutes and reach the max Z at the end of each print, there is a quite straightforward setup on the Cura SW.
Go t
https://www.thingiverse.com/thing:3333899.
Still uses the high voltage switch so please be careful.
The principle is; when the printer finish its job, it waits for 5 minutes and then move to max z axis. When the Max Z is reached one of the wheel mechanically touch a switch which interrupt the main power.
To make the Printer wait for 5 minutes and reach the max Z at the end of each print, there is a quite straightforward setup on the Cura SW.
Go t
Sign in to leave a comment
Sign in