Thingiverse
Auto-Rewind Spool Holder - T-slot mount
by Exerqtor
24
Downloads
18
Likes
0
Makes
Needed a T-slot mountable Auto Rewind spool holder so i made this puppy.
You need two M8 nylon locking nuts, and a M8 threaded rod cut to 130-135mm length.
Use the "round" spring from the Auto Rewind spool system.
Print it with a decent amount of top/buttom layers, walls and infill!
22.05.2019 v2:
After printing and fitting i saw there was room for some improvements, these are implemented in v2, and should now mate up a little better with the spring.
You need two M8 nylon locking nuts, and a M8 threaded rod cut to 130-135mm length.
Use the "round" spring from the Auto Rewind spool system.
Print it with a decent amount of top/buttom layers, walls and infill!
22.05.2019 v2:
After printing and fitting i saw there was room for some improvements, these are implemented in v2, and should now mate up a little better with the spring.
Sign in to leave a comment
Sign in