Anycubic Chiron Z Shaft Stabilizer / Pillow

If you've ever pulled your Chiron apart you will have noticed the mounts for the top of the z shafts are a bit sloppy (2mm or so play) This is designed to replace them outright and is part of an overhaul I am working on.

Pretty simple design, For each pillow you'll need 4 x 10mm M4 bolts, I like hex hey heads but whatever you like. 4 x M4 T-Nuts and a 22OD * 8ID *7mm high bearing.

I designed this so the bearing is a tight fit as to remove the need for additional bits or adhesives.

Insta