Thingiverse

DIY TOUCH-MI , wireless autolevelling Z-probe.Wireless part can be adapted to BLTouch and inductive sensors

by midelic

117 Downloads

91 Likes

0 Makes

Download Model

3d printer autolevel autoleveling auto bed leveling BLTouch diy DIY electronics electronics infrared infrared sensor proximity sensor sensor sensor mount Touch Mi touch-mi Wireless z-probe z probe

I hate using unnecessary wires.The other sensors use 3- 6 additional wires to connect routed to the ramps/MKS board.An inductive sensor is heavy and cable is big and heavy too.So in order to avoid that I designed a DIY Touch-MI Z-probe for auto-leveling a 3d printer without wires.
Description:
The signal from an optic probe(DIY touch-Mi) is sent wire less via an infrared light (IR diode) to an infrared sensor connected to a 3D Marlin board on the z-end switch connector.
The power for Z-probe

Source

Thingiverse

Comments