Thingiverse
Micro SD Card Key chain
by Kmaster05
2
Downloads
6
Likes
0
Makes
Print straight up with the hole on the bottom. Use a raft. Support if you want it at 50 degrees.
Post: After I printed it I decided to cut off the sides of the end and round the hole part. After I used a lighter to clean it up. To drill out the hole use a 1/4 inch bit. Everything will manipulate nicely if you printed at 100% infill.
Post: After I printed it I decided to cut off the sides of the end and round the hole part. After I used a lighter to clean it up. To drill out the hole use a 1/4 inch bit. Everything will manipulate nicely if you printed at 100% infill.
Sign in to leave a comment
Sign in